Receive notifications of new posts by email. MONITOR > VPN Monitor > IPSec.3.Go to FortiGate VPN > Monitor > IPsec Monitor and check the tunnel Status is up and Incoming Data/Outgoing. Ip nat inside source list 1 interface FastEthernet4 overload To test whether or not a tunnel is working, ping from a computer at one site to a computer at the other. I guess I am missing some configuration on the Cisco side.Ĭrypto isakmp key MyPresharedKey address 10.10.10.106Ĭrypto ipsec transform-set TS esp-3des esp-md5-hmac I can ping from the Fortigate LAN to the Cisco LAN however I cannot ping from the Cisco to the Fortigate. Configure the following settings in the Edit VPN Tunnel page. the Cisco ASA 5520 can also benefit from the Cisco VPN FLEX licenses. Select an IPsec tunnel and then select Edit to open the Edit VPN Tunnel page. Under Tunnel Mode Client Settings, select Specify custom IP ranges and ensure IP Ranges. Otherwise the default username and password is to leave both blank. Configure the secondary phase 1 to monitor the primary and adjust your DPD timers according to your needs. Go to ZyWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click Connect on the upper bar. Under Connection Settings, set Listen on Interface (s) to wan1 and Listen on Port to 10443. Turn off Enable Split Tunneling so that it is disabled. Also this could be great for SD-WAN monitor for tunels on branch sites, or for example as IP configured for the root Security Fabric FGT. Go to Monitor > IPSec Monitor and check the tunnel status on FortiGate Firewall. This helped me greatly to get a VPN tunnel up between my 2 devices (Fortigate 60C and Cisco 881W). On the FortiGate, go to VPN > SSL-VPN Portals, and edit the full-access portal. This article seems to be the reference for IPsec Site-to-Site (route-based) VPN between FortiGate and Cisco Router.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |